I have used the transfer switches when there are two sources for one load with success.
Is there a way to use them the opposite way? I want to use one source that can be transferred to two different loads.
In this scenario I have a generator that is connected to the network or to a load bank.
I have set the load bank up as a final circuit to an electric heater.
(https://i.postimg.cc/0zv1KQfz/Load-bank-ats.png) (https://postimg.cc/0zv1KQfz)
You can use "Active" tick box to enable/disable boards. On top of that, you may look into "Load calculation scenarios..." feature under Functions menu to create scenarios which make easier to switch between various configurations.
(https://i.postimg.cc/r0Wc4RD8/Active1.jpg) (https://postimg.cc/r0Wc4RD8)
(https://i.postimg.cc/Z9HsMTXr/Active2.jpg) (https://postimg.cc/Z9HsMTXr)