Hi,
I'm currently combining two switchboards and would like to move the primary supply to an ATS from one SB to another. I've tried a few methods and failed every time - can it be done?
The best I have managed is to copy the ATS over but this only copies the primary - do I then have to delete the original ATS and then re-supply the copied version with a new secondary supply?
Hi,
You can remove the supply cable of the open switch and reconnect the source using the switchboard functions > install power supply > From...
(https://i.postimg.cc/mP08Dwfb/sc-2-a.jpg) (https://postimg.cc/mP08Dwfb)
(https://i.postimg.cc/Y4Y8mWMQ/sc1-a.jpg) (https://postimg.cc/Y4Y8mWMQ)
Unless I'm missing something your proposal is another way of deleting some of my work to then redo it. I was hoping for something a little slicker.
To be honest, it is not clear what you want to achieve. A picture might help, but did you try to right-click > circuit functions > disconnect and then connect again?