Origin of Supply

[robw]

Hi,

I'm wanting to start a schematic showing the origin of supply as an existing sub distribution board and not a DNO supply.

Please can anyone assist? I'm sure its something obviously that i'm just missing but brand new to this software so figure its just quicker to ask.

Many thanks

[RCDGuy]

Well, EOM will require a source to run, however, there is a new component called Unknown network, which I think it is created for that purpose. You insert a supply and then this component. I would get rid of the conductor and protection but that's your choice. Then you can define a PFC and a Ze value at that point and carry on with the system as in your DB after this point.

I hope this helps.